OxyView™ is a pneumatic real-time oxygen flow meter for use with oxygen cylinders,
concentrators and other oxygen delivery systems. This device can measure the flow rate of
oxygen from 0-4.5 l/m. It can be attached at all times and used to assure and measure oxygen
flow rate. No batteries are required for product operation.
DIRECTIONS FOR USE
1 - OxyView™ Device
2 - Rubber Bushing Connectors
1. Cut large cannula oxygen hose 6" to 12" near
the cannula connection.
DO NOT cut hose above the cannula connection into the smaller
2. Connect the long end of the rubber bushing
connector to the large hose sections by firmly
pressing the large hose into the long end of
the rubber bushing connector, and connect
the OxyView™ to the short end of the rubber
bushing connector between the two sections.
All connections should be firmly placed.
OXYVIEW™ MAY BE PLACED ANYWHERE
BETWEEN THE CANNULA AND THE OXYGEN
SOURCE. IT MAY ALSO BE PLACED BETWEEN
THE EXISTING RUBBER BUSHING CONNECTORS
BETWEEN THE CANNULA AND THE HOSE
EXTENSION, OR AT THE REGULATOR.
WARNING: WHITE ARROW ON OXYVIEW SHOULD BE IN
DIRECTION OF OXYGEN FLOW, OR POINTING
TOWARD THE CANNULA.
Pneumatic real-time oxyen flow meter for use with oxygen cylinders, concentrators and other oxygen delivery systems.
$21.95 - Free Shipping!
Interior Red Piston
DIE-Trans Dark Red
Exterior Body Hot-Stamp Paint
1 3/8" Length and 7/16” Diameter
316 Stainless Steel
0.128 Ounces or 3.98 grams